Hi all, I feel like this may have been addressed before but I just wanted to check if anyone has been able to find a product or if they have any contacts that can make a rear diffuser similar to the styling of the 55 AMG but with a smaller exhaust gap for the OEM ones not the Quad Pipe
I only came across one but I didn't like the look of the angle of the fins and there was an extra section at the bottom which was a bit too over the top
Ideally looking for a gloss black finish instead of carbon and then I'm debating on adding white pin stripes on the fins to complete the look but I have attached the two references from my research
![Car Automotive Exterior Automotive lighting Bumper Mercedes-Benz]()
(image 1 is the diffuser with more of a straight cut on the fins and that extra line at the bottom running between the exhausts. The item is unpainted)
![Bumper Spoiler Mercedes-Benz Trunk Automotive Exhaust]()
(Image 2 is finished in carbon however the look of it is just so much cleaner without that extra line but it looks to be suitable for quad pipes which is something I want to avoid as my model is just an entry level but I just want to elevate the look of it)
I tried to create a render from GPT but it only used the first image but if anyone is able to help or assist it would be highly appreciated
![Land vehicle Vehicle Car Automotive lighting Automotive Exterior]()
I only came across one but I didn't like the look of the angle of the fins and there was an extra section at the bottom which was a bit too over the top
Ideally looking for a gloss black finish instead of carbon and then I'm debating on adding white pin stripes on the fins to complete the look but I have attached the two references from my research
(image 1 is the diffuser with more of a straight cut on the fins and that extra line at the bottom running between the exhausts. The item is unpainted)
(Image 2 is finished in carbon however the look of it is just so much cleaner without that extra line but it looks to be suitable for quad pipes which is something I want to avoid as my model is just an entry level but I just want to elevate the look of it)
I tried to create a render from GPT but it only used the first image but if anyone is able to help or assist it would be highly appreciated
